Filter
Top Products
To cancel Send All Calls
1
If you are using an 8410 with a display, press [
Menu ]
and then press the softkey below SAC again
(while on-hook)
If your 8410 does not have a display or if SAC is not
available on your display, press [
Send Calls ] again
(while on-hook)
or Dial Send All Calls cancel code
(while on-hook)
[confirmation tone]
Speaker
Note: Your voice terminal is set for either the Speaker (listen-only) or the
Speakerphone (listen and talk) function. Check with your system manager to see
which of these two features you can use.
You can use the Reset Speakerphone feature only if your voice terminal is set for
Speakerphone (listen and talk).
Use the following procedures if your voice terminal is set for the Speaker
(listen-only) feature.
To place a call without
lifting the handset, or to
use speaker with any
listening-only feature
activity (such as,
monitoring a call on
which you have been put
on hold or for group
listening)
Note: In order for the
other party to hear you,
you must speak through
the handset.
1
2
3
Press [
Speaker
]
●
Red light next to [ Speaker ] goes on; red light next
to [
Mute ] goes on
Place call or access selected feature
Adjust speaker volume if necessary
●
●
To raise the volume, press the right half of the
Speaker Volume control button labeled [
∧ ] ;
to lower the volume, press the left half of the
Speaker Volume control button labeled [
∨ ]
If you have a display, it shows
SPEAKER L>>>>> H
(There are eight possible volume settings. On the
display, one arrow is the lowest setting, and eight
arrows is the highest setting)
34