Filter
Top Products
Display Feature Procedures
This section includes the procedures for seven display features you may use with the
8410 voice teminal equipped with a display. However, note that the display, along
with the softkeys and display control buttons, can also be used for accessing up to
12 softkey features. For procedures on using the display and softkeys and a list of
the features that can be accessed with the softkeys, see “Using the Display, Softkeys,
and Display Control Buttons” earlier in this guide.
Call Information
You may have as many as 10 call appearance buttons. Beginning with the first
button in the upper left hand corner of your faceplate and going down, the display
identifies the buttons in the left column as a through e. The buttons in the right
column are identified as f through j. When the display shows [
a= ] it represents
call information for the first call appearance button. The next button down would be
shown as [
b= ] , and so on, continuing through [ j= ] if all 10 of the buttons
are used for call appearances.
When you dial an extension, that number is shown and then replaced by the called
party’s name and extension.
When a call is received from another extension, the caller’s name is shown; when a
call is received from outside, "OUTSIDE CALL" or a trunk identifier is shown.
The display remains in Normal (call-handling) Mode until you activate one of the
other display or softkey features. After using any of these features, return to
Normal (call-handling) Mode by pressing [
Exit ] .
39