Filter
Top Products
19
Quick Start
Quick Start
Reset to Default Factory Settings (Factory Reset)
If changes are made to the settings after purchase of the DR-670, you may be unable to operate the
unit as described in the Quick Start manual. If this occurs, then follow the instructions below to
restore the unit to the original factory settings (Factory Reset), then proceed to read Quick Start.
When Factory Reset is carried out, all data stored in the DR-670 is returned to the settings in effect
when the unit was shipped from the factory. If you already have important data saved in the DR-
670, save the data to an external MIDI device (such as a sequencer) using the bulk dump
procedure (p. 89), then carry out Factory Reset.
fig.00-05
1
While holding down [REC] and [STOP/CONT], turn on the DR-670’s power.
fig.00-06
2
Press [ ].
Along with an “OK,” a message confirming that you want to proceed with Factory Reset is displayed.
fig.00-07
If you want to cancel Factory Reset at this point, just turn off the power.
3
Press [ ] once more.
“DONE” appears in the display once the Factory Reset has been completed.
4
Turn off the power.
When the power is turned on again, the settings revert to those in effect when the unit was
shipped from the factory.
1,4
2,31