Filter
Top Products
76
Chapter 7 Customizing Your Setup (Utility Mode)
You can make the following settings in Utility mode.
● Switch the sounding/muting of drum parts
and bass parts (Output Part)
● Assign functions to the foot switches
● Change the roll interval (Roll Type)
● Change the flam settings
(Flam Interval, Flam Ratio)
● Adjust the key pad sensitivity (Pad Sens)
● Change the metronome settings
(Click Level, Click Beat)
● Tune the bass part (Master Tune)
Procedure
1. With the performance stopped, hold down
[SHIFT] and press Key Pad 13 (UTILITY).
The DR-670 switches to Utility mode.
fig.07-02
2. Press [ ] [ ] to select the
parameter with the settings you want to
change.
fig.07-03
3. Rotate the TEMPO/VALUE dial to change
the value of the setting.
4. Repeat Steps 2 and 3 as needed.
Switching the Sounding/
Muting of Drum Parts and
Bass Parts (Output Part)
fig.07-04
ALL: Both the drum part and the bass part
are played
DRUM: The drum part is played, and the bass
part is muted
BASS: The bass part is played, and the drum
part is muted
* Output Part settings are not saved. The function
always reverts to “ALL” when the DR-670’s
power is turned off.
* The Output Part settings are effective only with
respect to the playback of patterns. The Output
Part settings have no effect on the output when
you perform by playing the pads.
(Foot Switch 2)
(Roll Type)
(Flam Interval)
(Flam Ratio)
(Pad Sensitivity)
(Click Level)
(Click Beat)
(Master Tune)
(Foot Switch 1)
(Output Part)