16
Quick Guide
Enter Eect Edit mode
Press .
1
Editing: Editing the Eects
Select the eect that you want to edit
Finish editing
Edit the values
2
4
3
You can edit the parameters of each eect in the patch. Here we’ll show an example of editing the distortion of the overdrive eect.
Use to select OD/DS.
Press
.
Use
to edit the values
shown in the right display.
Turn the knob to
change the value.
You’ll be returned to the Play screen.
The edits you made here will be lost if you switch patches. If you want to keep the patch you created, press the [WRITE] button to save your edits as a user patch.
page 13
5
Turn knob [4] to select the eect
(the cursor will move).
You can use knob [3] to turn the eect on/o.
(Only if the cursor is located at FX1 or FX2) Use
knob [2] to select the eect type for FX1 or FX2.
Use knob [1] to move the position of the eect to
left or right.
Use the [PAGE] buttons to move between page tabs.
Convenient Quick Settings
If you select a page tab that shows “QS,” you’ll be able to easily call up settings (Quick Settings) that have been saved for each eect.
For details on how to save Quick Settings, refer to “Storing Settings by Eect (Quick Setting Write)” (p. 31).
What does each knob do?
The function (parameter) of each knob will dier depending on the eect. For a list of all parameters, download “GT-100 Parameter Guide” (PDF le) from
“GT-100” in the “Owner’s Manuals” list on the Roland website (http://www.roland.com/support/en/).
Switches the type of overdrive/distortion
Knob Operation Explanation
[5] TYPE Switches the type of overdrive/distortion.
[6] DRIVE Adjusts the amount of overdrive/distortion.
[7] TONE Adjust the tone quality. Higher values produce a sharper tone.
[8] EFFECT LEVEL Adjusts the volume when the eect is being applied.
MEMO
An eect can also be
selected by stepping on the
pedal that has been set in
Manual mode (p. 17).