Filter
Top Products
Using the GT-100 with External MIDI Devices Connected
48
5. Use knob [8] to select the patch number.
* In order to activate the use of a Program Change Map, you need
to set MAP SELECT (p. 45) to “PROG.” When this is set to “FIX,” the
settings for the Program Change Map will be ignored.
Receiving GT-100
MIDI IN
MIDI OUT
Transmitting
external MIDI
device
Transmitting Data to an External
MIDI Device (Bulk Dump)
With the GT-100, you can use Exclusive messages to set another
GT-100 to the same settings or to save eect sound settings to MIDI
sequencers and other such devices. This transmission of data is
referred to as bulk dump.
Making Connections
MEMO
For instructions on operating the sequencer, refer to the owner’s
manual for the sequencer you are using.
* If you want to save your settings to sequencer or DAW software
on your computer, refer to “Using the GT-100 Connected to a
Computer Via USB” (p. 49).
When Transmitting Data to Another GT-100
Connect as shown in the gure below, and match the Device ID for
the transmitting and receiving devices.
MIDI IN
MIDI OUT
Transmitting
GT-100
Receiving GT-100
Transmitting the Data
1. Press the [SYSTEM] button.
2. Turn knob [4] to select “B.DUMP” (MIDI - BULK DUMP).
3. Turn knobs [5] and [8] to select the range of data (FROM,
TO)that you want to transmit.
Knob Parameter Value Explanation
[5]
[8]
FROM
TO
SYSTEM System parameter settings
QUICK Settings for User Quick Setting
U01-1–U50-4
Settings for Patch Number U01-1
through U50-4
TEMP
Settings for the patch that is
currently selected
4. Press the [WRITE] button.
Bulk data transmission will begin.