Filter
Top Products
40
Making Global Settings (System Settings)
Settings that are shared by the entire GT-100 are called “system settings.”
Reference
For details, refer to “Editing: Basic Operation” (p. 12).
List of Settings
Item Parameter Value Explanation
OUTPUT SELECT
Specifying the Output Device You’re Using (OUTPUT SELECT)
Specify the device (amp) that’s connected to the OUTPUT jacks.
SELECT
JC-120, SMALL AMP,
COMBO AMP, STACK
AMP, JC-120 RETURN,
COMBO RETURN, STACK
RETURN, LINE/PHONES
Refer to “Specify the type of amp you’ve connected” (p. 9).
INPUT
Adjusting the Input Level from Your Guitar
Adjust the input level according to the output level of the guitar that you’ve connected.
INPUT LEVEL -20–+20 dB Adjusts the guitar input level.
GLOBAL EQ
Adjusting the Overall Tone (Global EQ)
This adjusts the tone of the OUTPUT regardless of the equalizer on/o settings of individual patches.
LOW GAIN -20–+20 dB Adjusts the low frequency range tone.
MID GAIN -20–+20 dB Adjusts the middle frequency range tone.
MID FREQ 20.0 Hz–10.0 kHz Species the center of the frequency range that will be adjusted by the MID GAIN.
MID Q 0.5–16
Adjusts the width of the area aected by the EQ centered at the MID FREQ. Higher values will narrow
the area.
HIGH GAIN -20–+20 dB Adjusts the high frequency range tone.
TOTAL
Adjusting the Overall Noise Suppressor, Reverb, and Output Level (Total)
These parameters control the threshold level of the noise suppressor used by each patch, the overall reverb level, and the overall output. They do not
aect the settings of each patch.
NS THRESH -20–+20 dB
Control the threshold level of the noise suppressor used by each patch. This does not aect the
settings of each patch.
* If you want to use the settings specied for each patch, set this to 0 dB.
REVERB 0–200 %
Adjusts the reverb level specied for each patch.
It is useful to adjust the reverb level appropriately for the space in which you’re performing. This does
not aect the settings of each patch.
* If you want to use the settings specied for each patch, set this to 100 %.
MAIN OUTPUT LEVEL -10 dB, +4 dB
Species the output reference level as appropriate for the input level of the device connected to the
OUTPUT jacks.
PHRASE LOOP
Making Phrase Loop (p. 32) Settings
Here are various settings for the Phrase Loop function. Refer to “Setting Phrase Loop” (p. 32)