Filter
Top Products
30
Saving a Tone
Saving a Patch (PATCH WRITE)
If you want to save the changes in the settings, carry out the Write
procedure.
NOTE
The patch previously stored at the write destination will be lost
once the write is executed.
1. Press the [WRITE] button.
2. Turn knob [4] to select “WRITE” (PATCH WRITE),
3. Turn knob [5] to select the write destination.
Assigning a name
To edit the patch name, use PAGE [ ][ ] buttons move the cursor
and use knob [8] to change the character.
Controller Operation
Knob [6] Selects the type of characters
Knob [7]
Switches between lowercase/uppercase
characters
Knob [8] Changes the character
PAGE [
][ ] button
Moves the cursor
[EZ TONE] button Deletes one character
[CTL/EXP] button Inserts one character
Turn the knob to
change the write
destination.
* If you decide to cancel without writing, press the [EXIT] button.
You’ll be returned to the Play screen.
4. Press the [WRITE] button once again.
The patch will be written.
Exchanging Patches (PATCH
EXCHANGE)
On the GT-100, you can “swap” or exchange the positions of two
User patches. The following explains how this is done.
1. Select the exchange source patch.
2. Press the [WRITE] button.
3. Use knob [4] to select “EXCHG” (PATCH EXCHANGE).
4. Turn knob [5] to select the other user patch that you want
to exchange.
* If you decide to cancel without exchanging, press the [EXIT]
button. You’ll be returned to the Play screen.
5. Press the [WRITE] button once again.
The patches will be exchanged.
Initializing Patches (PATCH
INITIALIZE)
You can return (initialize) a User patch to its original factory settings.
This is convenient when you want to create a new patch from
scratch.
NOTE
Any tone settings you’ve stored in a patch are lost once the
initialization is executed.
1. Press the [WRITE] button.
2. Use knob [4] to select the “PATCH INITIALIZE” screen.