Filter
Top Products
Pedal Settings (Control/Expression)
39
Quick Guide Overview Outputting Sound Eects Saving Pedal Settings System MIDI/USB Appendix
About the Range of a Controller’s Change
This sets the operational range within which the value of the setting changes when an expression pedal or other controller that changes
the value consecutively is used as the source. If the controller is moved outside the operational range, the value does not change, it stops at
“minimum” or “maximum.”
(Example) With ACT RANGE LO: 40, ACT RANGE HI: 80
When the
pedal is fully
raised
ACT
RANGE
LO
ACT
RANGE
HI
When the
pedal is fully
advanced
Degree to
Which Expres-
sion Pedal Is
Depressed
0 127
Allowable
Parameter
Settings Range
40 80
MAX
MIN
40 8060
Value
ON
OFF
Degree to
Which Expres-
sion Pedal Is
Depressed
0 127
When the
pedal is fully
raised
ACT
RANGE
LO
ACT
RANGE
HI
When the
pedal is fully
advanced
Center
Value
* When using a footswitch or other on/o switching controller as the source, leave these at “ACT RANGE LO: 0” and “ACT RANGE HI: 127.”
With certain settings, the value may not change.
Virtual expression pedal system (Internal Pedal / Wave Pedal)
By assigning a desired parameter to the virtual expression pedal, you can produce an eect as though you were operating a physical expression pedal
to change the volume or tone quality in real time.
The virtual expression pedal system provides the following two types of functions, and you can use the SOURCE (p. 37) setting for ASSIGN 1–8 to
choose the desired type.
* If you want to use the internal pedal or wave pedal, set the ASSIGN parameter SOURCE MODE to “MOMENT.”
Internal Pedal
If SOURCE is set to “INT PEDAL,” the virtual expression pedal will begin operating when started by the specied
trigger (INT PDL TRIGGER , p. 38), modifying the parameter specied by TARGET (p. 37).
Reference
For more detailed information on the parameters that can be set using Internal Pedal, refer to “INT PDL TRIGGER
(Internal Pedal Trigger)” (p. 41), “INT PDL TIME (Internal Pedal Time)” (p. 38), and “INT PDL CURVE (Internal Pedal
Curve)” (p. 38).
Wave Pedal
If SOURCE is set to “WAVE PEDAL” the virtual expression pedal will cyclically modify the parameter
specied by TARGET (p. 37) in a xed wave form.
Reference
For more detailed information on the parameters that can be set using Wave Pedal, refer to
“WAVE RATE (Wave Pedal Rate)” (p. 38) and “WAVEFORM (Wave Pedal Form)” (p. 38).
Input Level
Input Level
The parameter set as the target changes in response to the input level.
MEMO
If you want to adjust the input sensitivity, set the “INPUT SENS”(p. 37).
The value changes in
a curve
When the trigger occurs
Always changes in a xed curve regardless of the
actual pedal