Boss Audio Systems GT-100 DJ Equipment User Manual


  Open as PDF
of 68
 
27
Quick Guide Overview Outputting Sound Eects Saving
Pedal Settings
System MIDI/USB Appendices
Creating Sounds (Eects)
Setting the Eects
Use the left and right displays and knobs [1]--[8] to edit the settings
of the internal eects.
Reference
For details on the basic procedures for manipulating eects,
refer to ”Editing: Editing the Eects” (p. 16).
Specifying the Divider and Mixer
Modes
Within the eect chain, the point where the signal is split into
channels “A” and “B” is called the “divider,” and the point where the
two signals are recombined is called the “mixer.”
You can use the divider to switch between channels “A” and “B,” to
assign strongly picked notes and softly picked notes to dierent
channels, or to assign dierent frequency bands of your guitar
sound to dierent channels.
The mixer lets you adjust the volume balance of channels “A” and “B,”
place them in the stereo eld, or slightly delay the sound of channel
“B” to produce a spacious sound.
DIVIDER MIXER
Divider settings
1. Press the [EFFECT] button.
2. Use knob [4] to select “DIVIDER.”
3. Use knobs [5]–[8] and the PAGE [ ][ ] buttons to make
settings.
Con-
troller
Parameter Value Explanation
Page 1
[5] MODE
SINGLE
Use only one channel, either
“A” or “B.”
DUAL
Use the two channels “A” and
“B.”
Single mode settings
If you selected “SINGLE” with knob [5]
Con-
troller
Parameter Value Explanation
Page 1
[6] CH SELECT CH. A, CH. B Selects the channel to use.
Dual mode settings
If you selected “DUAL” with knob [5]
Con-
troller
Parameter Value Explanation
Page 2
[5]
CH. A
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
POLAR-
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
[6]
CH. A
DYNAMIC
SENS
0–100
Species the picking
sensitivity.
[7] CH. A FILTER
OFF The lter will not be used.
LPF
Only the region below the
cuto frequency will be
output.
HPF
Only the region above the
cuto frequency will be
output.
[8]
CH. A CUTOFF
FREQ
100 Hz–2 kHz Cuto frequency
Page 3
[5]
CH. B
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
POLAR-
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
[6]
CH. B
DYNAMIC
SENS
0–100
Species the picking
sensitivity.
[7] CH. B FILTER
OFF The lter will not be used.
LPF
Only the region below the
cuto frequency will be
output.
HPF
Only the region above the
cuto frequency will be
output.
[8]
CH. B CUTOFF
FREQ
100 Hz–2 kHz Cuto frequency
 previous next