Filter
Top Products
Section 14 – Maintenance and memory setups
06/97 – 1.00 – 14-3
3) Within menu group F, move the cursor so that
it is by the
field. The number of
whole hours that the head has been in use for
fast forward and fast rewind will be shown on
the bottom line of the display.
14.2 Memory backup
The DA-98 includes non-volatile memory
(NVRAM) which preserves almost all user set-
tings after the power is turned off.
14.3 User setups
You can save commonly-used setups in one of
three user setup memory banks: 1, 2 or 3. This
enables you to pre-configure the DA-98 for differ-
ent jobs (video or film post-production, or differ-
ent recording setups, for example). There is also a
preset memory bank which contains the factory
settings (see below).
When the DA-98 is shipped, the contents of all
setup memories are the same; they contain the fac-
tory settings.
14.3.1 Saving user setups
1) Go to menu group 9, move the cursor to
and press
ENTER
:
2) To store the current setup, use the
UP
and
DOWN
keys so that the bottom line reads
:
3) Move the cursor to
, or , and press the
UP
or
DOWN
key:
4) The word
will flash on the screen. To
save the current setup to the selected setup
memory, press the
UP
or
DOWN
key.
The word
will appear on the screen for
about 2 seconds and the user settings will be
stored to the selected setup memory bank.
14.3.2 Loading user setups
1) Go to menu group 9, move the cursor to
and press
ENTER
:
2) To load the setup memory into the current
memory, use the
UP
and
DOWN
keys so that the
bottom line reads
:
3) Move the cursor to
, or , and press the
UP
or
DOWN
key:
The word
will appear on the screen for
about 2 seconds..
The contents of the currently-selected setup will
be loaded into memory.