Filter
Top Products
Section 14 – Maintenance and memory setups
14-4 – 1.00 – 06/97
14.3.3 Resetting the memory
You may sometimes want to reset all of the mem-
ory to factory settings. The values of all the fac-
tory settings are listed in 12, “Menu and parameter
reference”.
1) Go to menu group 9, move the cursor to
and press
ENTER
:
2) Press
UP
or
DOWN
to select from
between
and .
3) Use the
RIGHT
key to move the cursor to
(factory). Press the
UP
key, and you will see the
word
flashing on the screen.
4) Press the
UP
key again to change the
to
This confirms that the memory has
been reset to factory settings.
14.4 Checking version
numbers
In case of problems, you may need to quote the
version number of the DA-98’s internal software
components to a TASCAM representative.
1) Use the cursor keys [25] so that the cursor is by
menu group F, and then press ENTER [27].
2) Within menu group F, move the cursor so that
it is by the
(system version),
(front panel software version),
(servo control software version)
or
(version of the
synchronization software) field. The version
number of the appropriate software will be
shown on the bottom line of the display.
14.4.1 Software upgrades
TASCAM pursues a policy of continuous
improvement to products, and there may be future
enhancements to the DA-98 software. Your TAS-
CAM dealer will be able to advise you of develop-
ments in this area.