Filter
Top Products
Reference: Configuration & Setup
6•5
to increase the digital output level of sounds that don’t have a lot of Amp Model or
stompbox distortion or other settings that are driving their levels up.
Format – selects the digital output’s format, either S/PDIF or AES/EBU for POD X3
Pro, S/PDIF for POD X3 and POD X3 Live.
System
Press and hold the Outputs / Hold for System button for 2 seconds to get to the System
page:
DIG LVLMODE
SYSTEM
PEDAL
TWK
CNTRL
BOTH
TONES
TWKLP SW
TONE1:
COMP
1-W/V
(2-VOL)
PEDAL
LP SW
TONE:1
DELAY
MIX
TONE:2
DELAY
MIX
TONE2:
COMP
PEDAL
TONE:1 TO E:2N
1-W/V
(2-VOL)
MSTVOL
OUTS
SETS
ALL
Press the 4-way Nav Up and Down to move between this and page 2.
System Page 1: Pedal and other settings
The Pedal-related settings here are for the wah/voume/tweak pedal built-in to POD
X3 Live, and the pedal on some FBV foot controllers that can be used with POD X3
and POD X3 Pro.
Pedal – use this to have the pedal affect either Tone 1, Tone 2 or Both.
Pedal Tone:1 & Pedal Tone:2 – The built-in pedal on a POD X3 Live and some FBV
foot controllers is pedal “1” and the optional external pedal you can connect to it is
pedal “2”. Here you can select what those pedals control, with these choices:
1-W/off 2-Vol – Pedal 1 controls Wah with the toe switch controlling Wah on/off. •
Pedal 2, if present, controls Volume.
1-Twk 2-Vol – Pedal 1 controls whatever is assigned to Tweak in the lower half of the •
LCD display. Pedal 2, if present, controls Volume.