Filter
Top Products
Example Setups
7•5
From the Home Page, turn the second knob below the display, and begin loading •
Tone 2 settings.
Selecting Tone 1 from the preset you just saved (you’ve copied Tone 1 to Tone 2).•
Set Tone 2’s Tone Volume low.•
Add more effects to Tone 2, cranking up the effect mixes, so you hear all or nearly •
all “wet” signal from Tone 2.
6. Save your preset, using WET in the name of Tone 2, so you’ll remember what it’s for.
Feed a Guitar Amp and Send Separate XLR Direct Outs (POD
X3 Live & POD X3 Pro only)
1. Connect 1/4-inch output(s) to your amp or speaker system.
2. Connect XLR output(s) to your recorder, mixer or PA.
3. On the first OUTPUTS page (1/4-inch Outputs):
Mode: Combo Front, Combo Pwramp, Stack Front, or Stck PwrAmp.•
Lows, Focus, Highs: as desired•
Tone 1: On•
Tone 1 Pan: as desired•
Tone 2: On•
4. On second OUTPUTS page (Studio/Direct Mix) set the XLR output signals:
Mode: Studio/Direct•
Tone 1: On•
Tone 1 Pan: as desired•
Tone 2: On•
Tone 2 Pan: as desired•
Tone 2 Pan: as desired•
5. Check your Master Volume.