Filter
Top Products
169
Chapter 10 Various Settings
Chapter10
❍
Functions that can be assigned (Expression
Pedals Only)
■
Changing the Bend Range
(Pedal Setting)
The effect of smoothly raising or lowering the pitch of a
played note is called the “bender effect.”
You can assign the bender function to a pedal, then apply the
bender effect by depressing and releasing the pedal.
You can also make a setting that determines how much the
pitch of the note changes when you apply the bender. The
maximum range of change in pitch is called the “bend
range.”
At Step 3 “Procedure” (p. 165), touch <Pedal Setting>.
Touch to switch the screens.
fig.d-pedalset.eps_50
Touch <Bend Range> to adjust the bend range
setting.
You can set this to any value within a range of 1 to 12 (in
half-tone steps, up to one octave).
Function
Explanation
Expression
Adjusts the overall volume.
EX1
When the pedal is pressed during a layer
performance, the Tone volume changes
between two levels, depending on how
firmly the pedal is pressed.
Pressing the pedal with “Pedal EX1”
selected increases the layer Tone volume.
The layer Tone is played at a fixed volume,
regardless of how forcefully the keys are
played.
EX2
Pressing the pedal with “Pedal EX2”
selected increases the layer Tone volume,
while the volume of the right-hand Tone is
decreased. The layer Tone is played at a
fixed volume, regardless of how forcefully
the keys are played.
EX3
Pressing the pedal with “Pedal EX3”
selected increases the layer Tone volume.
EX4
Pressing the pedal with “Pedal EX4”
selected increases the layer Tone volume,
while the volume of the right-hand Tone is
decreased.
KR117_r_e.book 169 ページ ２００５年１１月８日 火曜日 午後４時２０分