Filter
Top Products
117
Basic operation
PLAY mode
When you power up the PCR-30/50/80, it will start up in PLAY mode. The display will show
the current channel (p. 118).
* The PCR-30/50/80 will start up according to the Startup Memory settings (p. 164). With the factory
settings, it will start up with the GM2 MEMORY. For the messages that are assigned to each controller
by the GM2 MEMORY, refer to p. 164.
■ Controllers you can operate
* Octave Shift and Transpose are set independently.
* If you simultaneously press [OCTAVE -] and [OCTAVE +], the Octave Shift setting will be reset to 0.
* If you hold down [TRANSPOSE] and press [OCTAVE -] and [OCTAVE +] simultaneously, the Transpose
setting will be reset to 0.
[R1–R8], [S1–S8], [B1–B6]
[L1–L3], [P1, P2]
These controllers will transmit the messages that are assigned
to each.
* The transmitted value will be shown in the display.
[OCTAVE -/+]
Octave shift
* [OCTAVE -] or [OCTAVE +] will light depending on the current
octave shift setting. The actual octave shift value will appear in
the display only while you are editing the setting (-4–5).
[TRANSPOSE]+[OCTAVE -/+]
Transpose
* If you hold down [TRANSPOSE] for a while, [OCTAVE -] or
[OCTAVE +] will light depending on the current transpose
setting. The actual transpose value will appear in the display
only while you are editing the setting (-12–12).
Bender lever
Bender or modulation messages will be transmitted on the
current channel
Keyboard Note messages will be transmitted on the current channel