Filter
Top Products
32
Installing & Setting Up the Driver (Macintosh)
■ Setting the driver
1
Use the USB cable to connect the PCR-30/50/80 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
PCR-30/50/80.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-30/50/80 to your computer.
2
Set the PCR-30/50/80’s power switch to the ON position.
3
Make MIDI device settings on your sequencer software. For details on the
MIDI OUT/IN device to select, refer to “About the ports when using a USB
connection” (p. 159).
Cautions when using the PCR
Before you use your sequencer software, please note the following points.
* Connect the PCR-30/50/80 to your computer via a USB cable before you start up your sequencer or other
software.
* Do not disconnect the USB cable from the PCR-30/50/80 while your sequencer or other software
is running.
* Disconnect the USB cable from the PCR-30/50/80 only after you have quit your sequencer or other
software.
* Leave the Sleep function of your Macintosh turned off.
* The PCR-30/50/80 will not work in the Classic environment of Mac OS X. Use the PCR when the Classic
environment is not running.
For details on MIDI device
settings, refer to the
owner's manual for the
software you are using.
This completes the series of steps needed to connect the PCR-30/50/80 to the
Macintosh, install the MIDI driver, and make the driver settings.