Filter
Top Products
135
Edit mode (EDIT)
■ PROGRAM CHANGE ASSIGN
Here’s how to assign a program change message to a controller.
Basic mode
fig.edt
1
Press the [EDIT] button.
The display will indicate “EDT.”
2
Slightly move the controller to which you want to assign a Program Change message. In the
case of a button, press that button.
fig.r-1
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the [ENTER] button.
fig.pc0
4
Press the [PROGRAM CHANGE] key.
The display will indicate “PC0”.
fig.c
5
Confirm what’s indicated, and press the [ENTER] button.
The display will indicate “C--”.
*1 Reference
6
Input the channel. Use the [DEC][INC] buttons or the [0]–[F] keys to specify the channel.
fig.n
7
Press the [ENTER] button.
The display will indicate “N--”.
*1 Reference
8
Use the [DEC][INC] buttons or the [0]–[F] keys to specify the program change number.
9
Press the [ENTER] button.
* If you assign Basic mode to [S1--S8], [R1--R8], or [P2], moving the controller from the minimum to the
maximum position will transmit the assigned control change messages.
Mode Number Effect Bank Port
Basic mode 0 Fixed value Not output PCR 1
Advanced mode 1 1 Assignable range of values Not output PCR 1
Advanced mode 2 2 Fixed value Output Assignable
Advanced mode 3 3 PC DEC Not output KEYBOARD PORT (p. 154)
Advanced mode 4 4 PC INC Not output KEYBOARD PORT (p. 154)
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.