Filter
Top Products
26
Installing & Setting Up the Driver (Macintosh)
3
Double-click the PCR Driver-E Installer icon (found in the Driver E (Mac
OS 9, 8) folder of the CD-ROM) to start up the installer.
4
Verify the Install Location, and click [Install].
fig.3-2_40
5
If a message like the following is
displayed, click [Continue].
The other currently running
applications will exit, and
installation will continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
■ Setting the driver
OMS settings
1
Use the USB cable to connect the PCR-30/50/80 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
PCR-30/50/80.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-30/50/80 to your computer.
2
Set the PCR-30/50/80’s power switch to the ON position.
fig.3-3
3
From the CD-ROM, drag the Driver E (Mac OS 9, 8) -
OMS Setting folder to the hard disk of your Macintosh to
copy it.
fig.3-4
4
In the Opcode-OMS Application folder where you
installed OMS, double-click OMS Setup to start it up.
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.