Filter
Top Products
31
Chapter 4. Creating sounds — advanced section
Chapter 4
■ Setting the GK SW function
1. Press [PEDAL/ASSIGN].
fig.4-18
fig.4-10
2. Press [PAGE ] to move to Page 2.
fig.4-19a
3. Press [F1] (ON/OFF) to switch the GK SW function on or
off.
* You can also switch this by turning [VALUE].
4. Press [F4] (EDIT).
fig.4-20
5. Press [F1] (TARGET), and turn [VALUE] to select the
target.
6. Press [F4] (MIN), and turn [VALUE] to specify the
minimum value.
7. Press [F5] (MAX), and turn [VALUE] to specify the
maximum value.
8. Press [F6] (MODE), and turn [VALUE] to select the
desired mode.
* If MODE is set to “TOGGLE,” the S1 switch and S2 switch
will have the same function.
9. When you have finished making settings, perform the
Write operation (p. 25) if you wish to save them.
* If you do not wish to save the settings, press [EXIT] to return
to Play page.
■ Setting the Assign functions
Control assign settings are needed for controlling the
parameters by using the EXP pedal or CTL pedal on the VG-
88 or an external pedal or MIDI device. You can set up to 8
different functions (assign numbers 1 – 8) to each patch
number to determine which controller should control which
parameter.
Here’s how to make Assign 1 settings. Adjust these settings
as needed for your application.
1. Press [PEDAL/ASSIGN].
fig.4-21
fig.4-10
2. Press [PAGE ] to move to Page 2.
fig.4-19a
3. Press [F2] (ON/OFF) to switch the Assign function on or
off.
* You can also switch this by turning [VALUE].
fig.4-22a
4. Press [F5].
fig.4-23
5. Press [F1] (TARGET), and turn [VALUE] to select the
target.
6. Press [F4] (MIN), and turn [VALUE] to specify the
minimum value.