Filter
Top Products
60
Chapter 5. Parameter Guide
Specifies the operations of the VG-88’s built-in pedal and an
external pedal.
BANK SW MODE (bank switch mode)
Determines how the patch will change when you press the
BANK pedals.
WAIT NUM:
After changing the bank, press a number pedal [1]–[4] to
switch the patch.
NUMBER 1:
When you change the bank, patch number 1 of the
newly-selected bank will be chosen.
SAME NUM:
When you change the bank, the same-numbered patch as
in the previously-selected bank will be chosen.
BANK AREA (MIN) [1–65]
Specifies the lower limit of the bank pedals.
BANK AREA (MAX) [1–65]
Specifies the upper limit of the bank pedals.
SUB CTL1 (sub control pedal 1)
SUB CTL2 (sub control pedal 2)
Specifies the operation of the external device connected to
the SUB CTL 1,2 jack.
ASSIGNABLE:
The function can be assigned by each patch as a
parameter control pedal.
TUNER:
The tuner screen will be displayed.
BPM(TAP):
Tap input of the MASTER BPM parameter.
PU to FRONT:
Switch COSM GUITAR PICKUP sequentially toward the
front pickup.
PU to REAR:
Switch COSM GUITAR PICKUP sequentially toward the
rear pickup.
* When set to anything other than “ASSIGNABLE,” the
ASSIGN 1-8 SOURCE SUB CTL1 and SUB CTL2 settings
are disabled.
EXP/GK VOL HOLD
(EXP pedal/GK volume hold)
Select whether or not the EXP and GK VOL values will be
applied when a patch is recalled.
ON:
The values of the various controllers will be applied
when a patch is recalled. If you set the CTL pedal
operation to Latch and change patches when CTL is lit,
the settings at the time the patch was written will be
recalled.
OFF:
The patch will be recalled with the settings of when it
was written. (The values of the various controllers will
be ignored.)
EXP PEDAL CALIBRATION
Here's how to adjust the operation of the EXP pedal.
1. Return the built-in EXP pedal, and press [F4].
The display will indicate “ARE YOU SURE?”
2. If you wish to set, press [WRITE].
* If you do not wish to set the settings, press [EXIT] to return to
Play page.
3. Advance the built-in EXP pedal, and press [F6].
The display will indicate “ARE YOU SURE?”
4. If you wish to set, press [WRITE].
* If you do not wish to set the settings, press [EXIT] to return to
Play page.
Specifies the function of the VALUE dial.
FUNCTION
Selects the function of the VALUE dial.
P.NUMBER&VALUE:
In the Play page, the dial will change patches. In Edit
screens, it will function as a value dial.
VALUE ONLY:
It will function only as a value dial in Edit screens.
PEDAL
DIAL