Filter
Top Products
74
Chapter 8. Appendices
Can’t transmit/receive data via bulk dump
❍ Are you performing the operation in the bulk dump
transmit/receive screens?
Move to the bulk dump transmit/receive screens.
❍ Is the MIDI sequencer you are using able to record
exclusive data?
Use a MIDI sequencer that is able to record exclusive
data. We recommend that you use the Roland MC-80.
❍ When receiving, is the device ID number set to the
same value used when sending?
Set the device ID number to the same number that was
used when the data was sent.
Restoring the factory settings
(Initialization)
To restore the factory settings of the VG-88, do as follows.
You can initialize all settings, or only a specified section of
the patch data in the user area or system settings.
The following types of data can be initialized.
Display Data that is initialized
SYSTEM All system parameters
#1-1 – #25-4 The setting contents of patches 1-1 – 25-4
fig.8-03
1. Turn off the power.
2. While holding [PAGE ] and [PAGE ] down, switch
on the unit.
A display will appear, allowing you to specify the area of
data you wish to initialize.
fig.8-01
3. Move the cursor to “START” with [CURSOR], then use
the VALUE dial to get the display to show the data that
is the beginning point of the initialization.
4. Move the cursor to “END” with [CURSOR], then get the
display to show the ending point of the initialization,
also using the VALUE dial.
5. Press [WRITE].
The display will indicate “ARE YOU SURE?”
6. If you wish to initialize, press [WRITE].
The specified area of data will be initialized. The VG-88
will then be in its normal power-on state.
* If you decide not to initialize the settings, press [EXIT].
Initialization will be canceled, and the normal power-on
display will appear.
3,4
3,4
12