Roland VG-88 Musical Instrument User Manual


 
54
Chapter 5. Parameter Guide EFFECTS
This simulates the sound that reaches the listener after being
reflected from many surfaces (late reverberation).
ON/OFF
Switches the REVERB on/off.
* Turning [VALUE] will select PRESET.
MODE
This selects the reverb mode.
ROOM 1:
Simulates the reverberation of a small room. Provides
the bright reverberation of a live room.
ROOM 2:
Simulates the reverberation of a small room. Provides
warm reverberations.
HALL 1:
Simulates the reverberation of a concert hall. Provides
clear and spacious reverberations.
HALL 2:
Simulates the reverberation of a concert hall. Provides
warm reverberations.
PLATE:
Simulates plate reverberation (a reverb unit that uses the
vibration of a metallic plate). Provides a metallic sound
with a distinct upper range.
REV TIME (reverb time) [0.1–10.0 sec]
Adjusts the length (time) of reverberation.
LOW CUT (low-cut filter) [55.0 Hz–800 Hz]
The low-cut filter cuts the frequencies below the specified
frequency. This setting adjusts the frequency at which the
low-cut filter will begin to take effect.
HIGH CUT (high-cut filter)
[700 Hz–11.0 kHz, FLAT]
The high-cut filter cuts the frequencies above the specified
frequency. This setting adjusts the frequency at which the
high-cut filter will begin to take effect. When “FLAT” is
selected, the high-cut filter will have no effect.
PRE DLY (pre delay) [0–100 msec]
Adjusts the time until the reverb sound appears.
DENSITY [0–10]
This adjusts the density of the reverb sound.
REV LEV (reverb level) [0–100]
Adjusts the volume of the reverb sound.
This effect reduces the noise and hum picked up by guitar
pickups. Since it suppresses the noise in synchronization
with the envelope of the guitar sound (the way in which the
guitar sound decays over time), it has very little effect on the
guitar sound, and does not harm the natural character of the
sound.
* Please connect the noise suppressor prior to the reverberation
type effect. This setup will prevent unnatural break of the
reverberation type effect.
ON/OFF
Switches the noise suppressor on/off.
THRESHOLD [0–100]
Adjust this parameter as appropriate for the volume of the
noise. If the noise level is high, a higher setting is
appropriate. If the noise level is low, a lower setting is
appropriate. Adjust this value until the decay of the guitar
sound is as natural as possible.
* High settings for the threshold parameter may result in there
being no sound when you play with your guitar volume
turned down.
RELEASE [0–100]
Adjusts the time from when the noise suppressor begins to
function until the volume reaches “0.”
LEVEL [0–100]
This adjusts the volume.
SET PDL (setting pedal)
Assign the Foot Volume function to the built-in EXP pedal.
REVERB NS (noise suppressor)
FV (foot volume)