Filter
Top Products
14
Panel descriptions
16.
[POWER] Switch
Turns the power on/off (p.22).
17.
AC Inlet
Connect the included power cord here (p.17).
18.
USB FOR UPDATE Connector
This is used when updating the V-Piano’s internal operating
program.
Do not connect anything to this connector during normal use.
19.
DIGITAL OUT (COAXIAL) Connector
This is a coaxial type digital output jack. This will digitally output the
same audio as is output from the OUTPUT A jacks.
It complies with the S/PDIF format, and outputs a digital audio
signal (stereo).
* The [VOLUME] Knob will not adjust the volume of this connector.
Use the controls of your input device to adjust the volume.
* S/PDIF is a digital interface format that is used by consumer digital
audio equipment.
20.
USB MIDI Connector
When you want to use the included editor, use a USB cable to
connect this connector to your computer (p.58).
21.
[DISPLAY CONTRAST] Knob
Adjusts the contrast of the display (p.23).
22.
PIANO PEDAL Connector
Connect the included piano pedal here (p.20).
23.
DAMPER Connector / FC1 Connector / FC2 Connector
Connect separately sold pedals or switches here.
A variety of functions can be assigned to pedals connected to the
FC1 connector and FC2 connector (p.84).
24.
MIDI Connectors: IN, OUT/V-LINK, THRU
Connect these to external MIDI devices to transmit or receive MIDI
messages.
25.
INPUT Jacks: L/MONO, R
These are audio signal input jacks. You can connect an external
audio playback device here, and output its sound mixed with the
sound of the V-Piano.
* You cannot adjust the input level of these jacks, nor the balance
between these inputs and the V-Piano’s output.
26.
OUTPUT B Connectors: L/3, R/4
These are audio signal output jacks. The signal to be output from
these jacks can be selected from a menu (p.81).
You can use these jacks in conjunction with the OUTPUT A jacks to
output the V-Piano’s sound as four-channel output.
The phone jack and XLR connectors output the same signal.
27.
OUTPUT A Connectors: L/1, R/2
These are the main audio signal output jacks.
The phone jacks and XLR connectors output the same signal.
Rear panel
About the XLR OUTPUT connectors
This instrument is equipped with balanced (XLR) type jacks.
These jacks are wired as shown below. Make connections after
first checking the wiring diagrams of other equipment you
intend to connect.
fig.XLRTRSJack.eps
About the phone (1/4”) OUTPUT connectors
If you connect a phone plug to only the L/1 (and L/3) phone
jacks, they will output a mono signal that mixes-in the R/2 (and
R/4) signals, allowing you to use these as mono outputs.
* The XLR connectors will output a stereo signal.
* The V-Piano is designed to be used with stereo output. The
sound quality and tonal character will be affected if you use
monaural output.
V-Piano_e.book 14 ページ ２００９年１月２８日 水曜日 午前９時１０分