Filter
Top Products
82
Detailed settings for various functions (Utility screen)
fig.UtilTone.eps
The parameters in this group are the same as the parameters that you can edit in the Tone screen.
For an explanation of the parameters and their values, refer to “Customizing the V-Piano’s sounds” (p. 48).
ORIGINAL
This screen shows the name of the preset tone that was the basis of the customized tone.
* You cannot change the preset tone that was the basis of the customized tone.
Tone EQ
fig.UtilToneEQ.eps
Each tone allows you to apply an equalizer to specific regions (“Zones”). This is called the Tone EQ. For each tone you can specify four
Zones, and make different settings for each Zone.
fig.zone-1.eps
Of the four Zones, the settings of Zone 4 will take priority.
Each Zone has the following parameters.
Press the [F1 (ZONE)] button to switch between Zones.
Tone parameter settings (2. Tone Parameter)
Parameter
Value Description
Switch
OFF, ON Turns this ZONE’s EQ on/off.
Gain -12–+12 dB Adjusts the gain.
Frequency 16–16000 Hz Adjusts the center frequency.
Q 0.5, 1.0, 2.0, 4.0, 8.0
Adjusts the bandwidth.
Higher values will narrow the frequency range.
Key Range A0–C8 Sets the key range of this ZONE.
Zone 4
Zone 3
Zone 2
Zone 1
Priority
V-Piano_e.book 82 ページ ２００９年１月２８日 水曜日 午前９時１０分