Filter
Top Products
When a VS8F-1 effect expansion board is installed, you will be able to use two stereo effect units.
This chapter explains various examples of how the effects can be used. Read it in conjunction with
the VS8F-1 ownerÕs manual and ÒEffect relatedÓ (p.23) on this manual.
Examples of how the effects can be used
Here are several examples of ways in which the effects can be used. Apply these examples as
appropriate for your situation.
■ Applying reverb to a recorded performance (Loop)
Here we will explain the settings for adding reverb to the playback of track 1. In this case, the sig-
nal flow will be as follows.
1. Make sure that the mixer mode is INPUT➝TRACK.
2. Press channel 1 [CH EDIT(Input/BUSS)].
3. Use PARAMETER [][]to get the “MIX Sw=” display.
4. Rotate the TIME/VALUE dial. For this example, select “PstFade” so that the channel faders will
adjust the playback level.
If you do not want the direct sound to be output from the MIX buss, select ÒOff.Ó
MIX Sw (mix switch)
This selects how the signal will be sent to the MIX buss. If ÒOffÓ is selected, the MIX Level and MIX
Pan/MIX Bal parameters will not be available.
Off: not sent.
PreFade: The signal before passing through the channel fader will be sent to the MIX buss.
PstFade: The signal after passing through the channel fader will be sent to the MIX buss.
5. Hold down [SHIFT] and press channel 7 [EFFECT-1(CH EDIT)].
6. The signal will be sent to the EFFECT buss. Rotate the TIME/VALUE dial. For this example,
select “PstFade.”
EFFECT 1 (Effect 1 switch)
Specify how the signal is sent to the EFFECT 1 buss.
Off: The signal will not be sent.
PreFade: The signal will be taken before the channel fader.
PstFade: The signal will be taken after the channel fader.
Insert: The effect will be inserted between the equalizer and fader of the channel.
InsertL: Insert into the L side of a stereo effect.
InsertR: Insert into the R side of a stereo effect.
InsertS: Insert the L side and R side of a stereo effect in series.
* If the effect is inserted in another channel, the value will appear as ÒÑÐ,Ó and cannot be selected.
7. Press PARAMETER [ ].
The display will indicate ÒEFFECT1 Send=Ó.
Lev/Bal EFFECT1
MIX(L, R)
EFFECT1(L, R)
EFFECT2(L, R)
EQ
Fader
Level
Pan
Level
Pan
Pan
MIX Sw
EFFECT1
EFFECT2
Track 1
Channel 1
Lev/Bal
+
+
+
+
+
+
MASTER OUT(L, R)
Chapter 8 Using the internal effects
100