Filter
Top Products
18.Press [EDIT(SOLO)] several times until the display reads “MST EFF1 RTN to=”.
19.Rotate the TIME/VALUE dial. For this example, select “1-2” since we will be recording on
tracks 1 and 2.
EFF1 RTN to (Effect 1 return to)
Select the output destination of effect 1. The busses that can be selected will depend on the current
mixer mode.
When in INPUT MIX mode / TRACK MIX mode
MIX:
the MIX buss (stereo)
1-2: REC buss 1-2
3-4: REC buss 3-4
5-6: REC buss 5-6
7-8: REC buss 7-8
20.Press PARAMETER [ ].
The display will indicate ÒEFF1 RTN Lev=Ó.
21.Adjust the output level of effect 1. Rotate the TIME/VALUE dial.
EFF1 RTN Lev (Effect 1 return level)
Set the output level (0Ð127) of effect 1.
22.Press PARAMETER [ ].
The display will indicate ÒEFF1 RTN Bal=Ó.
23.Adjust the left/right volume balance of effect 1. Rotate the TIME/VALUE dial.
EFF1 Bal (Effect 1 balance)
Set the left/right volume balance (L63Ð0ÐR63) of effect 1.
24.Press [EFFECT] several times until the display reads “EFF EFFECT-1 PRM ?”.
25.Press [YES].
26.Select effect 1. Rotate the TIME/VALUE dial. For this example, select an effect such as A00
RV:LargeHall.
27.. Press [YES].
28.Set the track status of tracks 1 and 2 to REC.
When you begin recording, the direct sound and reverb sound will be recorded.
■ Applying a vocoder while you record (Insert)
Here we will explain how you can connect an instrument such as a keyboard to INPUT 1 and a mic
to INPUT 2, and record a vocoded sound in stereo onto tracks 1 and 2. In this case the signal flow
will be as follows.
EQ
Fader
Level
Pan
Level
Pan
Pan
MIX Sw
EFFECT1
EFFECT2
MASTER OUT(L, R)
Lev/Bal
MIX(L, R)
Track 1
EQ
Fader
Level
Pan
Level
Pan
Pan
MIX Sw
EFFECT1
EFFECT2
Track 2
Effects
L L
R R
+
+
+
+
Level
Level
Level
Level
Channel 1
Channel 2
Chapter 8 Using the internal effects
104