Filter
Top Products
Using the 3-band equalizer
1. Make sure that the mixer mode is INPUT MIX/TRACK
MIX.
If it is INPUT➝TRACK, holding down [SHIFT] and
pressing [SELECT].
2. Press [EDIT(SOLO)] several times until “MST EQ Sel=”
appears.
3. Rotate the TIME/VALUE dial.
EQ Sel (Equalizer Select)
Select the type of equalizer that you wish to use.
2BandEQ: 14 channels of 2-band equalizers (same as
Ver.1).
3BandEQ: 8 channels of 3-band equalizers.
■ Mixing in a stereo source
(Stereo In)
Even when playing back all 8 tracks in INPUT➝TRACK,
you can now mix in a stereo source for output to master
out.
For example, this is convenient when two VS-880 units are
being operated in synchronization.
1. Press [EDIT(SOLO)] several times until “MST
StereoIn=” appears.
2. Select the input source for the stereo source. Rotate
the TIME/VALUE dial.
StereoIn (Stereo In)
Off: Stereo In will not be used.
Input12: Inputs 1 and 2 will be input in stereo.
Input34: Inputs 3 and 4 will be input in stereo.
Digital: The digital input will be input in stereo.
3. Press PARAMETER [ ].
The display will indicate ÒMST StIn Level=Ó.
4. Adjust the volume level of the stereo input. Rotate the
TIME/VALUE dial.
5. Press PARAMETER [ ].
The display will indicate ÒMST StIn Bal=Ó.
6. Adjust the left/right balance of the stereo input. Rotate
the TIME/VALUE dial.
■ Adjusting the level of each track
(Track Level)
It is now possible to adjust the volume level of each track
independently from the channel faders.
For example, this is convenient when you wish to raise the
track level for playback of a track which was recorded at a
low volume level.
1. Press [CH EDIT] for the track whose volume you wish
to adjust.
2. Press PARAMETER [ ] several times until
“TrackLevel=” appears.
3. Rotate the TIME/VALUE dial.
TrackLevel (Track Level)
The volume level of each track can be adjusted over a range
of -12Ð12dB.
■ Causing top panel fader and
pan knob operations to take
effect immediately
When the volume or pan has been adjusted in Channel Edit
condition, switching between INPUT MIX and TRACK MIX
can cause the fader or pan knob locations to no longer
match the actual volume level or pan. In such cases, an Ò
✱Ó
symbol will be appended to the displayed values of the set-
tings. Also, when the fader or pan locations are shown in
the bar display, the current channel fader locations will
blink.
1. Press [SYSTEM] several time until “SYS System PRM
?” appears.
2. Press [YES].
3. Press PARAMETER [ ] several times until “SYS
FaderMatch” appears.
4. Rotate the TIME/VALUE dial.
FaderMatch (Fader Match)
Select how the faders will act when the fader or pan knob
locations do not match the actual volume level or panning.
Null: Changes will not occur until the channel
fader or pan knob is moved to the actual
value (same as Ver.1).
Jump: The actual value will change at the instant
that the fader or pan knob is moved.
5. Press [PLAY(DISPLAY)].
You will return to Play condition.
Chapter 1 Trying out the expanded functions
21
Chapter 1