Filter
Top Products
3. Use the TIME/VALUE dial to select “PstFade.”
This will cause effects to be applied. With this selection, the signal flow will be as follows.
4. Adjust the send level (input level) for the effect. Press PARAMETER [ ] to get the
“EFFECT1 Send” display. Rotate the TIME/VALUE dial to adjust the send level. Play back the
song and adjust the volume balance between the direct sound and the sound processed by the
effect.
5. Press [EFFECT]. In response to the “EFFECT-1 PRM?” message, press [YES].
The number and name of the currently selected effect will appear, allowing you to select the
type of effect. If the display shows ÒEFFECT-2 PRM?,Ó press PARAMETER [ ] to get the
ÒEFFECT-1 PRM?Ó display and then press [YES].
6. Use the TIME/VALUE dial to select the type of effect (Patch), and press [YES].
As you rotate the TIME/VALUE dial, the number and name of the displayed effect will
change, and will be blinking. When you press [YES], the display will stop blinking, and the
effect that is displayed will be selected.
Each of the 300 effects is assigned a number A00ÐA99, B00ÐB99 and U00ÐU99. They are
referred to as ÒPatches.Ó A00ÐA99 and B00ÐB99 are Preset Patches (which cannot be modified),
and U00ÐU99 are User Patches (whose settings can be modified). At the factory settings, the
User Patches contain the same effects as the Preset Patches A00ÐA99.
The contents of the Preset Patches are listed in the included VS8F-1 Preset Patch list sheet.
Some of the Preset Patches are of a type which add an effect sound to the original sound
(Loop), while others are of a type which modifies the original sound itself (Insert). Since in this
example we want to apply an effect to the entire song, select a Loop type effect patch.
7. After you have selected an effect patch, press [PLAY (DISPLAY)] to return to Play condition.
Each channel settings
EFFECT 1 (Effect 1 switch)
Specify how the signal is sent to the EFFECT 1 buss.
Off: The signal will not be sent.
PreFade: The signal will be taken before the channel fader.
PstFade: The signal will be taken after the channel fader.
Insert: The effect will be inserted between the equalizer and fader of the channel.
InsertL: Insert into the L side of a stereo effect.
InsertR: Insert into the R side of a stereo effect.
InsertS: Insert the L side and R side of a stereo effect in series.
* If the effect is inserted in another channel, the value will appear as ÒÑÐ,Ó and cannot be selected.
CONDITION MARKER#
MASTER
INPUT TRACK
AUX
TIMETIME
48
24
4
0
dB
1122
EQ Fader
Post
Pre
Off
Post
Pre
Off
Insert
Level Pan
Pan
EFFECT 1 buss
MIX buss
Channel 1
MASTER OUT (L, R)
BalanceLevel
Return to
MIX
EFFECT 1
Chapter 3 Basic operation (as a replacement for a tape MTR)
70