Filter
Top Products
■ Applying reverb while bouncing tracks (Loop)
Here we will explain the settings for applying an effect to previously-recorded tracks and record-
ing the sound to another track. For example, this will be convenient when you wish to apply
reverb to an entire song and mix it down.
In this example we will apply reverb to tracks 1Ð6 and bounce them to tracks 7 and 8. In this case,
the signal flow will be as follows.
1. Make sure that the mixer mode is INPUT➝TRACK.
2. Press channel 1 [CH EDIT(Input/BUSS)].
3. Use PARAMETER [ ][ ] to make the display read “CH1 MIX Sw=”.
4. Rotate the TIME/VALUE dial. For this example, select “PstFade” so that the channel faders will
adjust the recording level.
MIX Sw (mix switch)
This selects how the signal will be sent to the MIX buss. If ÒOffÓ is selected, the MIX Level and MIX
Pan/MIX Bal parameters will not be available.
Off: not sent.
PreFade: The signal before passing through the channel fader will be sent to the MIX buss.
PstFade: The signal after passing through the channel fader will be sent to the MIX buss.
5. Hold down [SHIFT] and press channel 7 [EFFECT-1(CH EDIT)].
6. Send the signal to the EFFECT buss. Rotate the TIME/VALUE dial. For this example, select
“PstFade” so that the channel faders will adjust the send levels.
EFFECT1 (Effect 1 switch)
Select how the signal will be sent to the EFFECT1 buss.
Off: The signal will not be sent.
PreFade: The signal from before the channel fader will be sent.
PstFade: The signal that passed through the channel fader will be sent.
Insert: Insert between the equalizer and fader.
InsertL: Insert into the L side of a stereo effect.
InsertR: Insert into the R side of a stereo effect.
InsertS: Insert the L side and R side of a stereo effect in series.
* If the effect is inserted in another channel, the value will appear as ÒÑÐ,Ó and cannot be selected.
7. Press PARAMETER [ ].
The display will indicate ÒCH1 EFFECT1 Send=Ó.
8. Adjust the send level to effect 1. Rotate the TIME/VALUE dial.
EQ
Fader
Lev/Bal
Level
Pan
Level
Pan
Pan
MIX Sw
EFFECT1
EFFECT2
Lev/Bal Effect1
MIX(L, R)
EFFECT1(L, R)
EFFECT2(L, R)
Channel 1–6
+
+
+
+
+
+
EQ
Level
Pan
Level
Pan
Pan
MIX Sw
EFFECT1
EFFECT2
Channel 7, 8
Recorder
Channel 7
Track 7
Track 1
Recorder
Fader
Channel 1
MASTER OUT(L, R)
+
+
Chapter 8 Using the internal effects
106