Filter
Top Products
– 29 –
GROUP FADER : 43[H] 47[H] 46[H] 41[H],42[H] (‘CGFA,B’)
43[H] 47[H] 46[H] 31[H]-36[H] (‘CGF1-2’)
This command is used to set any desired single channel of the GROUP FADER.
Various setups can be memorized in the scene memories by specifying these scene Nos.
The commands that correspond to the respective channels are shown below.
• Packet format
43[H] 47[H] 46[H] 41[H] “parameter” 0D[H]
(In the case of MASTER A)
• Parameter
This parameter consists of the 13-byte data all the time in the order as shown in the table below.
When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.
When you specify the scene No.(31[H] (‘1’) to 44[H] (‘D’)), parameters of the subsequent 2nd to 13th bytes are written in the scene
memory.
• Scene No. (1st byte)
GROUP FADER Command
MASTER A 43[H] 47[H] 46[H] 41[H] ‘CGFA’
MASTER B 43[H] 47[H] 46[H] 42[H] ‘CGFB’
REMOTE 1 43[H] 47[H] 46[H] 31[H] ‘CGF1’
REMOTE 2 43[H] 47[H] 46[H] 32[H] ‘CGF2’
REMOTE 3 43[H] 47[H] 46[H] 33[H] ‘CGF3’
REMOTE 4 43[H] 47[H] 46[H] 34[H] ‘CGF4’
REMOTE 5 43[H] 47[H] 46[H] 35[H] ‘CGF5’
REMOTE 6 43[H] 47[H] 46[H] 36[H] ‘CGF6‘
byte Parameter name
1st SCENE No.
2nd-9th INDEX
10 th MIC INPUT FADER
11 th LINE INPUT FADER
12th LINE OUTPUT1-6 FADER
13th LINE OUTPUT7,8 FADER
SCENE No. SCENE No. SCENE No.
NONE 30[H] (‘0’) 7 37[H] (‘7’)14 3E[H] (‘>’)
131[H] (‘1’) 8 38[H] (‘8’)15 3F[H] (‘?’)
232[H] (‘2’)9 39[H] (‘9’)16 40[H] (‘@’)
333[H] (‘3’)10 3A[H] (‘:’)17 41[H] (‘A’)
434[H] (‘4’)11 3B[H] (‘;’)18 42[H] (‘B’)
535[H] (‘5’)12 3C[H] (‘<’)19 43[H] (‘C’)
636[H] (‘6’)13 3D[H] (‘=’)20 44[H] (‘D’)