Filter
Top Products
– 52 –
• LINE3-4F machine type (1, 3, 5, 7, 9, 11 and 13th byte)
This command is used to set category of the Control S.
• LINE3-4F connection (2, 4, 6, 8, 10, 12 and 14th byte)
This command is used to set the output channel of the CONTROL S signal.
• CONTROL S I/F TYPE (15th byte)
This command is used to set the connection type of the channels 1 to 4 of the CONTROL S OUTPUT terminal.
When you want to set the I/F type to WIRED, set the corresponding bit to 0. When you want to set the I/F type to IR, set the
corresponding bit to 1.
Bits 4 through 7 are fixed all the time.
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 CH4 CH3 CH2 CH1
CONNECTION CONNECTION CONNECTION CONNECTION
TYPE TYPE TYPE TYPE
• PJ CONTROL (16th byte)
This command is used to set ON/OFF of the REMOTE POWER ENABLE and selection of the PROJECTOR CONTROL terminal with
the 8-bit data.
When you want to set the REMOTE POWER ENABLE to ON, set bit 1 to 1. When you to set it to OFF, set bit 1 to 0.
Bit 0 (I/F) changes depending on the setup of the “Projector Protocol” described later.
Bits 2 through 7 are fixed all the time.
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 0 0 REMOTE I/F
POWER
ENABLE
CHANNEL TYPE
10[H]‘@’)
21[H]‘A’)
32[H]‘B’)
44
4
4
4
3[H] (
(
(
(
‘C’)
NONE 30[H] (‘0’)
1.00 and higher
DVD 31[H] (‘1’)
1.00 and higher
VTR1(Beta) 32[H] (‘2’)
1.00 and higher
VTR2(8mm) 33[H] (‘3’)
1.00 and higher
VTR3(VHS) 34[H] (‘4’)
1.00 and higher
VTR4(DV) 35[H] (‘5’)
1.00 and higher
MD 36[H] (‘6’)
1.00 and higher
CD 37[H] (‘7’)
1.00 and higher
CD-R 38[H] (‘8’)
1.00 and higher
Blu-ray Disc
39[H] (‘9’)
1.30 and higher
VTR(Inst.)
3A[H] (‘:’)
1.30 and higher
Cassette Deck
3B[H] (‘;’)
1.30 and higher
MACHINE TYPE
Supported firmware
version