Filter
Top Products
– 59 –
SCENE RECALL BUTTON PARAMETER REQUEST :
52[H] 52[H] 53[H] 41[H] (‘RRSA’)
This command is used to read the scene Nos. that are set to the SCENE RECALL A to D buttons on the front of the SRP-X700P.
• Packet format
52[H] 52[H] 53[H] 41[H] 0D[H]
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the
order shown below.
41[H] “parameter” 0D[H]
The parameter is the same as that of the SCENE RECALL BUTTON command.
SCENE STORE : 43[H] 53[H] 54[H] 52[H] ( ‘CSTR’ )
This command is used to store the scenes to the scene memory.
The procedure to store the scenes to the scene memory is shown below.
1. Specify the scene numbers that you want to store using the respective commands of MIC INPUT, LINE3 INPUT, LINE4 INPUT,
ROUTING, LINE OUTPUT 1 and 2, LINE OUTPUT 3 through 8, REC OUT, SPEAKER OUTPUT, MUTING/LINE 4 SELECT
and GROUP FADER. Then send the parameters that you want to store, to the scene memory.
2. Send the SCENE STORE command to store the scenes.
• Packet format
43[H] 53[H] 54[H] 52[H] “parameter” 0D[H]
• Parameter
The parameter consists 11 bytes all the time in the order as shown in the table below.
Method of setting index is the same as that of the GROUP FADER command. See page 29.
byte Parameter name
1st SCENE No.
2nd-9th INDEX
10th FUNCTION1
11th FUNCTION2