Filter
Top Products
– 49 –
• OUTPUT Function 1 (25, 27, 29, 31, 33, 35, 37, 39, 41, 43rd byte)
This command is used to set the PARALLEL OUTPUT function 1.
• OUTPUT Function 2 (26, 28, 30, 32, 34, 36, 38, 40, 42, 44th byte)
This command is used to set the PARALLEL OUTPUT function 2.
The different functions are supported for the respective values depending on the setup of the PARALLEL OUTPUT function 1.
Example: When setting the respective parameters as shown below.
INPUT1 function 1 : AV SEL
INPUT1 function 2 : B
INPUT2-12 function 1 : NONE
INPUT2-12 function 2 : NONE
OUTPUT1 function 1 : RECALL
OUTPUT1 function 2 : 1
OUTPUT2-10 function 1 : NONE
OUTPUT2-10 function 2 : NONE
43[H] 4D[H] 54[H] 53[H] 31[H] 31[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H]
30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H]
34[H] 32[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 30[H]
30[H] 30[H] 30[H] 30[H] 30[H] 30[H] 0D[H]
(‘C P I O 1 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 4 2 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 CR’)
FUNCTION1
NONE 30[H] (‘0’)
AV SEL 3
3
1[H] (
(
‘1’)
2[H] ‘2’)
OVER 33[H] (‘3’)
RECALL 34[H] (‘4’)
PJ 35[H] (‘5’)
–∞
FUNCTION2
NONE
AV
SEL Over
RECALL PJ Power
NONE A Mic1 1 On 30[H] (‘0’)
B Mic2 2 Standby 31[H] (‘1’)
C Mic3 3 32[H] (‘2’)
D Mic4 4 33[H] (‘3’)
E MicLine5 5 34[H] (‘4’)
F MicLine6 6 35[H] (‘5’)
OFF Line3 7 36[H] (‘6’)
Line4 8 37[H] (‘7’)
Out1 9 38[H] (‘8’)
Out2 10 39[H] (‘9’)
Out3 11 3A[H] (‘:’)
Out4 12 3B[H] (‘;’)
Out5 13 3C[H] (‘<’)
Out6 14 3D[H] (‘=’)
Out7 15 3E[H] (‘>’)
Out8 16 3F[H] (‘?’)
MasterA 17 40[H] (‘@’)
MasterB 18 41[H] (‘A’)
19 42[H] (‘B’)
20 43[H] (‘C’)
-∞