Filter
Top Products
42 Agilent E1538A Enhanced Frequency/Totalize/PWM SCP
SCPI Command Reference
Most of the E1538’s commands were available since its introduction. A small
number of commands are only available with E1538’s built after February
1998. The following table indicates these new commands with an X in the
"for newer units only" column. See "Identifying the Plug-on" on page 5
Table 2.
Command Syntax For newer
units only
Page
Discussed
INPut:POLarity NORM | INV,(@<
ch_list
>)
44
INPut:POLarity? (@<ch_list>) 44
INPut:THReshold[:LEVel] <level>,(@<ch_list>) 45
INPut:THReshold[:LEVel]? (@<channel>) 45
[SENSe:]FUNCtion:CONDition (@<ch_list>) 50
[SENSe:]FUNCtion:FREQuency (@<ch_list>) 51
SENSe:FREQuency:APERture <time>,(@<ch_list>) 47
SENSe:FREQuency:APERture? (@<channel>) 48
SENSe:FREQuency:LIMit:LOWer <freq_limit>,(@<ch_list>) X 48
SENSe:FREQuency:LIMit:LOWer? (@<channel>) X 50
[SENSe:]FUNCtion:PERiod (@<ch_list>) X 51
SENSe:PERiod:APERture <time>,(@<ch_list>) X 56
SENSe:PERiod:APERture? (@<channel>) X 57
SENSe:PERiod:LIMit:UPPer <per_limit>,(@<ch_list>) X 57
SENSe:PERiod:LIMit:UPPer? (@<channel>) X 59
SENSe:PERiod:MODE APERture | NPERiods,(@<ch_list>) X 59
SENSe:PERiod:MODE? (@<channel>) X 60
SENSe:PERiod:NPERiods <count>,(@<ch_list>) X 60
SENSe:PERiod:NPERiods? (@<channel>) X 61
SENSe:PERiod:RANGe[:UPPer] <count>,(@<ch_list>) X 61
SENSe:PERiod:RANGe[:UPPer]? (@<channel>) X 62
[SENSe:]FUNCtion:PWIDth <avg_count>,(@<ch_list>) 52
[SENSe:]FUNCtion:QUADrature [<preset_count>,](@<ch_list>) 52
[SENSe:]FUNCtion:RVELocity <n_teeth>,<index_type>,(@<ch_list>) 53
[SENSe:]FUNCtion:TOTalize (@<ch_list>) 55
[SENSe:]TOTalize:RESet:MODE INIT | TRIG,(@<ch_list>) 62