Filter
Top Products
24 Operating Basics
01V96i—Owner’s Manual
•Effect page
This page displays the internal effects processor 1–4
input and output levels altogether.
•Stereo page
This page displays the Stereo Out output level.
If you selected the CH1-32 page or the Master page,
use the MASTER MODE parameter to select one of
the following three metering signal types:
• GATE GR.............The amount of gain reduction
for the gate (only for CH1-32)
• COMP GR...........The amount of gain reduction
for the compressor
• LEVEL ..................Input Channel input level, or
Output Channel output level
4. To activate the Peak Hold function, move
the cursor to the PEAK HOLD button,
then press [ENTER].
The PEAK HOLD button turns on, and the peak
level is held on the meters on the page. To cancel the
Peak Hold function, turn the PEAK HOLD button
off.
Tip: These pages also allow you to change the metering
position using the POSITION parameter. This param-
eter setting operates in unison with the Meter | Position
page setting.