Filter
Top Products
50 Troubleshooting
01V96i—Owner’s Manual
Signal level is low at a specific
frequency
❍ Could the EQ gain be excessively low?
❍ Routing a signal through GEQ or an effect will delay it relative to other signals. If
a signal is mixed with the same signal routed differently, a comb filter effect will
decrease the level at specific frequencies.
Can’t control the 01V96i console from
01V96i Editor
❍ Refer to the 01V96i Editor installation guide on the website.
The 01V96i console is not recognized
by your DAW software
❍ Have you downloaded and installed the Yamaha Steinberg USB Driver?
❍ You must connect the 01V96i to the computer and power-on the 01V96i before
you start up your DAW software.
❍ Check the driver settings and device settings of your DAW software.
Signals are not recorded on your
DAW software
❍ Are the input ports set appropriately on your DAW software?
❍ If you’re using Cubase, are the VST connection settings appropriate?
❍ Is the signal you want to record being routed to one of USB1–16?