Filter
Top Products
Changing the Channel Names 43
01V96i—Owner’s Manual
Tutorial
Changing the Channel
Names
You can change the default name of the input channels
(Input Channels 1–32, ST IN Channels 1–4) and output
channels (Aux Outs 1–8, Bus Outs 1–8, Stereo Out), if
you desire.
Changing the Input Channel
Names
1. Press the DISPLAY ACCESS [PATCH] but-
ton repeatedly until the Patch| In Name
page appears.
Channel IDs, Short names, and Long names are
listed from left to right on the page. You can specify
Short names in the parameter boxes (
1) in the
center column, and Long names in the parameter
boxes (
2) in the right column.
2. Move the cursor to the desired parame-
ter box, then use the Parameter wheel or
the [INC]/[DEC] buttons to select a port
for which you want to change the name.
3. Press [ENTER].
The Title Edit window appears, which enables you
to edit the name.
4. Edit the name, move the cursor to the OK
button, then press [ENTER].
The new name is now effective.
When the Name Input Auto Copy check box (
3) is
on, the first four characters of a newly-entered Long
name are automatically copied to the Short name.
On the other hand, a newly-entered Short name is
automatically added to the beginning of the Long
name.
You can reset all port names to their default names
by moving the cursor to the INITIALIZE button,
then pressing [ENTER].
Changing the Output Channel
Names
To change output channel names, press the DISPLAY
ACCESS [PATCH] button repeatedly until the Patch |
Out Name page appears.
The procedure for editing the names and using the
Name Input Auto Copy check box and the INITIALIZE
button is the same as on the In Name page.
13 2
Tip: The edited name is stored in the Input Patch
library.