Filter
Top Products
14
Chapter 1 Playing Sounds
Making Settings for a Connected
Device (Amp) (Output Select)
Select the type of device connected to the OUTPUT jack.
■ Procedure
1. Press [OUTPUT SELECT], causing the indicator to
light.
The Output Select settings screen appears.
fig.01-10
2. Turn the PATCH/VALUE dial to select the type of
device connected to the OUTPUT jack.
* When connecting to the input on a guitar amp, set the guitar
amp’s tone controls so BASS is at 0, MIDDLE (midrange) is
at 10, and TREBLE is at 0. If the amp has switchable channels,
select the normal (clean) channel.
JC-120:
Use this setting when connecting to Roland’s JC-120
guitar amp.
SMALL AMP:
Use this setting when connecting to small guitar amp.
COMBO AMP:
Use this setting when connecting to the guitar input of a
combo amp other than the JC-120 guitar amp (where the
amp and speaker or speakers are combined in a single
unit).
* Depending on you guitar amp, you may be able to obtain good
results with the “JC-120” setting.
STACK AMP:
Use this setting when connecting to the guitar input of a
stack-type guitar amp (where the amp and speaker or
speakers are separated).
COMBO RETURN:
Use this setting when connecting to RETURN with a
combo amp.
STACK RETURN:
Use this setting when connecting to RETURN of a stack
amp or rack mounted power amp.
LINE/PHONES:
Use this setting when using headphones or when
connecting to a multi-track recorder for recording.
LINE (PA):
Use this setting when connecting to a mixer or other PA
device.
To derive the maximum performance from the GT-6,
be sure to make the correct setting for OUTPUT
SELECT, the one that’s most suitable for your setup.
Guitar Tuning
You can use the GT-6’s built-in “tuner function” to tune
your guitar.
For instructions on using this function, refer to “Tuning
the Guitar” (p. 57).