Filter
Top Products
37
Chapter 4 The Effects Explained
Chapter
4
● SYN; Guitar Synth
Sensitivity 0–100
Wave Square, Saw, Brass, Bow
Chromatic Off, On
Wave= Square, Saw
Octave Shift 0, -1, -2
Wave= Square, Saw
PWM Rate 0–100 Wave= Square
PWM Depth 0–100 Wave= Square
Cutoff Frequency 0–100
Resonance 0–100
Filter Sensitivity 0–100
Filter Decay 0–100
Filter Depth -100 –100
Attack Decay, 0–100
Release 0–100
Velocity 0–100
Hold Off, On
Wave= Square, Saw
Synth Level 0–100
Direct Level 0–100
● SEQ; Sub Equalizer
Low EQ -20 dB–+20 dB
Low-Middle Frequency 100 Hz–10.0 kHz
Low-Middle Q 0.5–16
Low-Middle EQ -20 dB–+20 dB
High-Middle Frequency 100 Hz–10.0 kHz
High-Middle Q 0.5–16
High-Middle EQ -20 dB–+20 dB
High EQ -20 dB–+20 dB
Level -20 dB–+20 dB
On/Off (effect on/off)
Switches the FX-2 effect on/off.
FX Select (effect select)
This selects the effect to be used.
■ PH (Phaser)
By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
Type
Selects the number of stages that the phaser effect will use.
4Stage:
This is a four-phase effect. A light phaser effect is obtained.
8Stage:
This is an eight-phase effect. It is a popular phaser effect.
12Stage:
This is a twelve-phase effect. A deep phase effect is obtained.
Bi-Phase:
This is the phaser with two phase shift circuits connected in
series.
Rate
This sets the rate of the phaser effect.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Depth
Determines the depth of the phaser effect.
Manual
Adjusts the center frequency of the phaser effect.
Resonance
Determines the amount of resonance (feedback). Increasing
the value will emphasize the effect, creating a more unusual
sound.
Step
This sets on/off of the step function. When the step function
is turned on, the change of a sound will be in steps.
Step Rate
This sets the cycle of the steps that changes the rate and
depth. When it is set to a higher value, the change will be
finer.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [ ] to display
the Master BPM settings screen.
Effect Level
This adjusts the volume of the phaser.
Direct Level
This adjusts the volume of the direct sound.