Filter
Top Products
49
Chapter 5 Settings for Using the Expression and Control Pedals (Pedal Assign)
Chapter
5
Controlling Effects with the GT-6 Pedals,
External Pedals, and External MIDI Devices
Make these settings when controlling effects with the GT-6’s
expression pedal or CTL pedal, or with pedals or external
MIDI devices connected to the GT-6.
You can make up to eight separate settings per patch (using
Assign numbers 1–8) determining what parameters are
controlled by which controllers.
fig.05-07
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to display the
following screens.
fig.05-08
3. Rotate the VALUE dial to change the setting’s value.
4. Repeat Steps 2 and 3 as needed until the settings are
completed.
5. To save the settings, use the Write procedure (p. 22).
Press [EXIT] to return to the Play screen.
Assign ON/OFF
fig.05-09
This selects the eight Assign ON/OFF settings (ASSIGN 1–8).
Only set the assigns you will be using to “On.”
* Be sure to set any Assign settings not being used to “Off.”
Making Settings Instantly (Quick Setting)
Using Quick Setting lets you automatically make the settings
to the parameters described below, without having to set
them all individually.
As you rotate the PATCH/VALUE dial in the Assign ON/
OFF screen to select the prepared pedal settings, the most
appropriate values for the parameters are selected instantly.
P01: PATCH LEVEL
P02: PREAMP GAIN
P03: OD/DS DRIVE
P04: DELAY LEVEL
P05: CHORUS LEVEL
P06: REVERB LEVEL
P07: MASTER BPM
P08: SUB EXP FV
P09: SUB EXP FW
P10: SUB EXP PS
1
3
2
Assign On/Off
Quick Setting
Target
Target value range: Min
Target value range: Max
Source
Source Mode
Active Range Low
Active Range High
(Examples)