Filter
Top Products
68
Chapter 9 Using MIDI
fig.09-19
When the transmission is completed, the screen prior to
transmission returns to the display.
4. Press [EXIT] to return to the Play screen.
Receiving Data from an External
MIDI Device (Bulk Load)
Making the Connections
When Receiving Data Saved on a MIDI Sequencer
Connect as shown below. Set the GT-6’s Device ID to the
same number that was used when the data was transmitted
to the MIDI sequencer.
fig.09-02
* For instructions on operating the sequencer, refer to the
owner’s manual for the sequencer you are using.
Receiving
1. Press [UTILITY], then press PARAMETER [ ]
[] so that “Bulk Load” is displayed.
fig.09-20
2. Transmit the data from the external MIDI device.
The following appears in the display when the GT-6
receives the data.
fig.09-21
The following appears in the display when the GT-6
finishes receiving the data.
fig.09-22
At this stage, even more data can be received.
3. Press [EXIT] to quit Bulk Load.
After you press [EXIT], “Checking...” appears in the
display, indicating that the GT-6 is checking the received
data. When the check is completed, the Play screen
returns to the display.
MIDI OUT
MIDI IN