Filter
Top Products
54
Chapter 6 Using the Customize Function
SpeakerLow -50–+50
Adjusts the speaker section’s low-frequency tone.
SpeakerHigh -50–+50
Adjusts the speaker section’s high-frequency tone.
Making “Custom” Overdrive/
Distortion Settings
Here you can make two different sets of settings, Custom 1
and Custom 2.
* Any patch tone using Custom 1 or 2 will be altered if the
custom settings are edited.
1. Turn the OVERDRIVE/DISTORTION TYPE knob to
“CUSTOM/EXTERNAL.”
2. Press OVERDRIVE/DISTORTION [TYPE
VARIATION] to call up “Custom1” or “Custom2.”
fig.06-03
3. Press [OVERDRIVE/DISTORTION].
The OVERDRIVE/DISTORTION edit screen appears.
4. Press PARAMETER [ ] [ ] to show the custom
parameters.
fig.06-04
5. Rotate the PATCH/VALUE dial to change the setting’s
value.
6. Repeat Steps 4 and 5 as needed.
7. Press [EXIT] to return to the Play screen.
Type
Selects the basic speaker type.
OD-1:
This is the sound of the BOSS OD-1.
OD-2:
This is the sound of the BOSS OD-2.
CRUNCH:
This is a crunch sound of the BOSS BD-2.
DS-1:
This gives a basic, traditional distortion sound.
DS-2:
This creates a heavier distortion sound.
METAL1:
This is the sound of the BOSS MT-2.
METAL2:
This gives a heavy metal sound.
FUZZ:
This models a FUZZFACE.
Bottom -50–+50
Adjusts the amount of distortion in the low frequencies.
Top -50–+50
Adjusts the amount of distortion in the high frequencies.
Low -50–+50
Adjusts low-frequency tone.
High -50–+50
Adjusts the high-frequency tone.
Custom
Type
Custom
Bottom
Custom
Top
Custom
Low
Custom
High