Filter
Top Products
48
Chapter 5 Settings for Using the Expression and Control Pedals (Pedal Assign)
Pedal Settings for the CTL Pedal
P01: OD/DS
P02: DELAY
P03: CHORUS
P04: EQ
P05: FX-1
P06: FX-2
P07: WAH
P08: TUNER
P09: BPM (TAP)
P10: MANUAL
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to display the
following screens.
(Expression pedal switch)
fig.05-04
(CTL pedal)
fig.05-05
You can rapidly switch to the two screens above by
holding down [ ] (or [ ]) and pressing [ ] (or
[ ]).
3. Rotate the PATCH/VALUE dial to select the pedal
setting.
* If not using the expression pedal or CTL pedal, select “Off.”
4. Repeat Steps 2 and 3 as needed.
5. To save the settings, use the Write procedure (p. 22).
Press [EXIT] to return to the Play screen.
Editing “Quick Settings”
Whenever necessary, you can edit parameter values set in the
Quick Settings.
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to display the
following screens.
fig.05-06
3. Rotate the PATCH/VALUE dial to change the setting’s
value.
4. Repeat Steps 2 and 3 as needed.
5. To save the settings, use the Write procedure (p. 22).
Press [EXIT] to return to the Play screen.
Target
The parameter to be controlled.
Target Variation Range
This sets the range within which the parameter being
controlled will change.
The range between the minimum value (Min) and the
maximum value (Max) is changed.
Source Mode
This selects the function of the foot switch (p. 51)
Expression Pedal Switch
Target
Expression Pedal Switch
Target value range: Min
Expression Pedal Switch
Target value range: Max
Expression Pedal Switch
Source Mode
CTL Pedal
Target
CTL Pedal
Target value range: Min
CTL Pedal
Target value range: Max
CTL Pedal
Source Mode
(Examples)