Filter
Top Products
26
Chapter 4 The Effects Explained
Parameter Value
Custom Type (1–3) JC Clean, TW Clean, Crunch,
VO Lead, BG Lead,
MS1959 Stk, MODERN Stk
Custom Bottom -50–+50
(1–3)
Custom Edge -50–+50
(1–3)
Custom Bass Freq -50–+50
(1–3)
Custom Treble Freq -50–+50
(1–3)
Custom Preamp Low -50–+50
(1–3)
Custom Preamp High -50–+50
(1–3)
Custom SpeakerLow -50–+50
(1–3)
Custom SpeakerHigh -50–+50
(1–3)
Gain
Adjusts the distortion of the amp.
Bass
Adjusts the tone for the low frequency range.
Middle
Adjusts the tone for the middle frequency range.
Treble
Adjusts the tone for the high frequency range.
Presence
Adjusts the tone for the ultra high frequency range.
* If you have selected “MATCH DRY” or “VO COMBO” as
the type, raising presence will cut the high range (the value
will change from 0 to -100).
Level
Adjusts the volume of the entire preamp.
* Be careful not to raise the Level setting too high.
Bright
Turns the bright setting on/off.
Off:
Bright is not used.
On:
Bright is switched on to create a lighter and crisper tone.
* Depending on the “Type” setting, this may not be displayed.
Gain SW (Gain Switch)
Provides for selection from three levels of distortion: Low,
Middle, and High. Distortion will successively increase for
settings of “Low,” “Middle” and “High.”
* The sound of each Type is created on the basis that the Gain is
set to “Middle.” So, normally set it to “Middle.”
Speaker SW
Turns the speaker simulator on/off.
SPEAKER TYPE
1x10”:
This is a compact open-back speaker cabinet with one 10-inch
speaker.
1x12”:
This is a compact open-back speaker cabinet with one 12-inch
speaker.
2x12”:
This is a general open-back speaker cabinet with two 12-inch
speakers.
4x12”:
This is an optimal speaker cabinet for a large enclosed amp
with four 12-inch speakers.
8x12”:
This is a double stack of two cabinets, each with four 12-inch
speakers.
ORIGINAL:
This is the built-in speaker of the amp you selected with
“Type.”
Mic Settting
This simulates the microphone position. “Center” simulates
the condition that the microphone is set in the middle of the
speaker cone. “1–10 cm” means that the microphone is
moved away from the center of the speaker cone.
Mic Level
Adjusts the volume of the microphone.
Direct Level
Adjusts the volume of the direct sound.
* If you’ve chosen “Full Range” for Type, use with Mic Level =
100 and Direct Level = 0.