Filter
Top Products
60
Chapter 7 Convenient Features of the GT-6
Reverb Level 0%–200%
Adjusts the reverb level settings for each patch in a range
from 0% to 200%.
Adjusting the reverb level is an effective way to match the
reverberation of the performance venue.
* Set to “100%” when using this in individual patch settings.
* This has no effect on patches in which reverb is turned off.
Using External Effect Processors
You can use external effect processors connected to the
EXTERNAL jack on the rear panel in place of the GT-6’s
overdrive and distortion.
In order to use external effect processors, the OVERDRIVE/
DISTORTION TYPE must be set to “External.”
fig.07-15
1. Press [OVERDRIVE/DISTORTION]; the indicator
lights up.
2. Turn the OVERDRIVE/DISTORTION TYPE knob to
CUSTOM/EXTERNAL.
3. Press
OVERDRIVE/DISTORTION [TYPE VARIATION]
a number of times until the indicator lights green and
“External” is displayed.
fig.07-16
4. Press [EXIT] to return to the Play screen.
• You can adjust the level of the signal sent to the external
effect processor (the send level) with the OVERDRIVE/
DISTORTION DRIVE knob.
• You can adjust the level of the signal sent back from the
external effect processor (the return level) with the
OVERDRIVE/DISTORTION LEVEL knob.
Using the Digital Outs
Digital signals are output from the DIGITAL OUT connector
on the rear panel. You can connect this directly to the digital
in connector of a digital recorder or other device and record
with no degradation in sound quality.
fig.07-18
Checking the Effect Output
Level with the Level Meter
You can meter the output level of each effect. This is handy
for checking the effects’ output levels.
1. Press [UTILITY] a number of times until “METER” is
displayed.
* You can also select this by pressing [UTILITY], and then
pressing PARAMETER [ ] [ ].
fig.07-19
2. Rotate the PATCH/VALUE dial to select the effect
whose level you want to check.
* Only effects that are turned on can be selected.
* You can check the level of signals being input to the INPUT
jack by selecting “Input.” Selecting “Output” allows you to
check the level of signals output from the GT-6.
* You may not be able to achieve the effects you envision if your
output levels are set too high. Adjust the output level of each of
your effects to the optimum value while checking the meter
and making sure the needle doesn’t swing too far to the right.
3. Press [EXIT] to return to the Play screen.
2
1
3
DIGITAL IN