Filter
Top Products
108
Effects
Dynamics (Dynamic)
a: Envelope Select
When L/R Mix is selected for this parameter, the left and right
channels are linked to control the Limiter using the mixed sig-
nal. If L Only (or R Only) is selected, the left and right channels
are linked, and the Limiter is controlled via only the left (or
right) channel.
With L/R individually, the left and right channels control the
Limiter individually.
b: Ratio
c: Threshold [dB]
e: Gain Adjust [dB]
This parameter sets the signal compression “Ratio”. Compres-
sion is applied only when the signal level exceeds the “Thresh-
old” value.
Adjust the output level using the “Gain Adjust” parameter, since
compression causes the entire level to be reduced.
a
Envelope
Select
L/R Mix,
L Only, R Only,
L/R Individ-
ually
Selects from linking both channels,
controlling only from left channel,
only from the right channel, or
controlling each channel individ-
ually
bRatio
1.0 : 1…
50.0 : 1,
Inf : 1
Sets the signal compression ratio
c Threshold [dB] –40...0
Sets the level above which the
compressor is applied
v
Attack 1...100 Sets the attack time
Release 1...100 Sets the release time
e
Gain Adjust
[dB]
–Inf,
–38...+24
Sets the output gain
Src Off...Tempo
Selects the modulation source for
the output gain
Amt –63...+63
Sets the modulation amount of the
output gain
f
Side PEQ Insert Off, On
Toggles between on/off of the
trigger signal’s EQ
Trigger
Monitor
Off, On
Switches between effect output
monitor and trigger signal monitor
g
Side PEQ
Cutoff [Hz]
20...12.00k
Sets the EQ center frequency for the
trigger signal
Q 0.5...10.0
Sets the EQ bandwidth for the
trigger signal
Gain [dB] –18.0...+18.0
Sets the EQ gain for the trigger
signal
h
Wet/Dry
Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
Left
Right
FX Control BUS 1
FX Control BUS 2
FX Amt
FX Amt
Stereo In - Stereo Out
Limiter
Limiter
Envelope Source
Gain Adjust
Gain Adjust
Side PEQ
Envelope - Control
Envelope - Control
Trigger Monitor
+
Envelope Select
Input Level
Output Level
Threshold
Ratio=1.0 : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Ration=Inf : 1
Louder
Louder
Time
Level
Threshold
Ratio=Inf : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Dry
Ratio=1.0 : 1
Limiter - Threshold / Ratio