Korg PA3 Recording Equipment User Manual


 
114
Effects
EQ and Filters (EQ/Filter)
a: Mode
b: Frequency Bottom
b: Frequency Top
c: Resonance Bottom
c: Resonance Top
If Mode=Preset, this simulates a vintage wah pedal. In this case,
internally fixed values are used for Frequency Bottom/Top and
Resonance Bottom/Top, and these settings will be ignored. The
settings for Frequency Bottom/Top and Resonance Bottom/Top
are valid if Mode=Custom.
13: VOX Wah
This models the legendary VOX V847 and V848 Clyde McCoy
wah pedals. Its distinctive tone, sounding as though it were
wrung from the throat, made this pedal a favorite of many pro
musicians.
14: St. Random Filter
(Stereo Random Filter)
This stereo band pass filter uses a step-shape waveform and ran-
dom LFO for modulation. You can create a special effect from
filter oscillation.
a: LFO Phase [degree]
Offsetting the left and right phases alters how modulation is
applied to the left and right channels, creating a swelling affect.
a: LFO Waveform
b: LFO Frequency [Hz]
c: LFO Step Freq [Hz]
When “LFO Waveform” is set to Step-Tri, LFO is a step-shape,
triangle waveform. The “LFO Frequency” parameter sets the
original triangle waveform speed. Changing the “LFO Step Freq”
parameter enables you to adjust the width of the steps.
When “LFO Waveform” is set to Random, the “LFO Step Freq”
parameter uses a random LFO cycle.
Type V847, V848 Selects the type of wah
Open 1...100
Sets the lower limit of the wah center
frequency page 113
Close 1...100
Sets the upper limit of the wah center
frequency page 113
Mode
Pedal(Dmod)
, Auto
Switches between pedal wah and auto-
wah
Pedal Source 0...100
Specifies the modulation source that will
use the pedal wah
Pedal Manual 0...100
Sets the center frequency for the pedal
wah when the modulation source is not
moved
Auto Sensitivity 0...100 Sets the auto-wah sensitivity
Auto Polarity
Auto,
D-mod,
LFO
Specifies whether the auto-wah sweep is
normal or inverted
Auto Attack Sets the auto-wah’s attack speed
Wet/Dry Balance between the wet and dry signal
Source
Table , “Selects a modulation source for
Wet/Dry,” on page 107
Amount
Table , “Sets the modulation amount for
Wet/Dry,” on page 107
a
LFO Waveform
Step-Tri,
Random
Selects the LFO Waveform
LFO Phase
[degree]
–180...+180
Sets the LFO phase difference
between the left and right
D
-mod
Auto Sensitivity
Envelope
Mode
Pedal(D-mod)
Auto
Wet / Dry
Left
Right
Wet / Dry
+
Wah
Attack / Polarity
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Filter
Left
Right
FX Amt
FX Amt
Stereo In - Stereo Out
Filter
LFO Phase
LFO: Step-Tri/Random
b
LFO Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO
Src Off...Tempo
Selects the modulation source used
for both LFO speed and step speed
Amt
–20.00...
+20.00
Sets the modulation amount of LFO
speed
c
LFO Step Freq
[Hz]
0.05...50.00
Sets the LFO step speed (speed that
changes in steps
Amt
–50.00...
+50.00
Sets the modulation amount of LFO
step speed
d
MIDI Sync Off, On
When this is on, the LFO speed is set
by BPM, Base Note, and Times,
instead of Frequency
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note r...w
Selects the type of notes that
specify the LFO speed
Times x1...x32
Sets the number of notes that
specify the LFO speed
e
Step Base Note r...w
Selects the type of notes to specify
the LFO step speed
Times x1...x32
Sets the number of notes to specify
the LFO step speed
f
Manual 0...100 Sets the filter center frequency
Src Off...Tempo
Selects the modulation source for
the filter center frequency
Amt –100...+100
Sets the modulation amount for the
filter center frequency
g
Depth 0...100
Sets the modulation depth of filter
center frequency
Src Off...Tempo
Selects the modulation source of
filter modulation
Amt –100...+100
Sets the modulation amount of filter
modulation
h Resonance 0...100 Sets the resonance amount
i
Wet/Dry
-Wet, -
1:99...Dry...99:1
, Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
0 +90
+180 [degree]
0 [degree]
–90
–180
LFO Phase