Filter
Top Products
Operation
25
Step 3. Recording
1. Recording methods
This section explains the different recording methods
available on the PXR4.
For basic recording, refer to “Quick Start.”
Recording on two tracks
Here’s how to record on two tracks simultaneously.
1 Connect the input device.
Lower the PXR4’s [MASTER] fader, set the [INPUT
SELECT] switch to LINE, and connect your keyboard
etc. to the [LINE INPUT] jack.
2 Specify two tracks for recording.
Press two [REC SELECT] keys (1–2 or 3–4) to specify
the tracks that you want to record, adding two “ ”
symbols to the track numbers in the display.
You can also listen to rhythm while you record. (→p.41)
3 Use the level meters to check the input levels.
Hold down the [SHIFT] key and press the [MIXER]
key to change the “DISPLAY” setting in the screen to
“PRE” (pre-fader level).
While watching the level meter, play sounds on your
input source (instrument), and use the [INPUT TRIM]
knob to adjust the input level so that the level does not
reach “CLIP” when the loudest sounds are produced.
You can also apply an effect to the input source. (→p.36)
To listen to the sound that is being input, raise the [TRACK]
faders and the [MASTER] fader to about 6.
[LINE INPUT]
[OUTPUT L/R]
LINE