Filter
Top Products
Appendices
87
Display indicates “CdFormat”
Was the card formatted (initialized) on the PXR4?
(→p.61)
→ If you are using a card that was initialized on another
device such as a computer or digital camera, you will
need to initialize the card on the PXR4.
Is the card inserted correctly? (→p.12)
→ Turn off the power, re-insert the card, and then turn
the power on once again.
Display indicates “CdRecvry”
Did you turn off the power of the PXR4 while the card
was being accessed? (→p.61)
→ It is possible that the data in the card has been dam-
aged. Execute the Card Recovery operation to recover
the data.
USB
Your computer does not recognize the PXR4
Is the USB cable connected correctly? (→p.52)
→ Re-connect the cable.
Your computer does not release the PXR4
The procedure will depend on the operating system of
your computer. (→p.52)
When you connect the PXR4, you are requested to install
software or a device driver
Does the operating system version of your computer
support the PXR4? (→p.52)
Messages
CardLock
While USB-connected, it is forbidden to remove the
card from the PXR4.
→ Do not disconnect the USB cable when this message is
displayed. Doing so may damage the data in the card.
Data can be written from the computer to the card
inserted in the PXR4.
CdFormat
(→p.87: Display indicates “CdFormat”)
CdNotRdy
While USB-connected, no card is inserted into the
PXR4, or the card cannot be accessed.
→ Insert a card. If a card is already inserted, turn off the
power, re-insert the card, and then turn the power on
once again. In this state, it is possible to disconnect the
USB connection.
CdRecvry
(→p.87: Display indicates “CdRecvry”)
CrdReady
While USB-connected, the computer is ready to access
the card inserted in the PXR4.
→ Data can be written from the computer to the card
inserted in the PXR4. In this state, it is possible to dis-
connect the USB connection.
CrdRetry
The card cannot be detected correctly, or is in a state in
which access is not possible.